CTS Sedan RWD V6-3.0L (2010)
7. Assemble the brake hose fitting bolt (1) and 2 new brake hose fitting gaskets (2) to the brake hose (3).
8. Install the brake hose assembly to the caliper and tighten the fitting bolt to 49 Nm (36 lb ft).
9. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) (See: Brake Bleeding/Service and Repair)Hydraulic
Brake System Bleeding (Pressure) (See: Brake Bleeding/Service and Repair).
10. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair).
11. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
12. Slowly release the brake pedal.
13. Wait 15 seconds, then repeat steps 11 and 12 until a firm brake pedal apply is obtained. This will properly seat the brake caliper piston and brake
pads.
14. Fill the brake master cylinder reservoir to the proper level. Refer to Master Cylinder Reservoir Filling (See: Brake Master Cylinder/Service and
Repair/Procedures/Master Cylinder Reservoir Filling).
15. Set the electronic park brake cable tension, if equipped. Refer to Parking Brake Cable Adjuster Enabling (Electric Park Brake) (See: Parking
Brake System/Parking Brake Cable/Service and Repair/Procedures/Parking Brake Cable Adjuster Enabling (Electric Park Brake)).
