CTS Sedan RWD V6-3.0L (2010)
Engine Mount: Service and Repair
Engine Mount Bracket Replacement - Right Side
Engine Mount Bracket Replacement - Right Side (w/RWD)
Removal Procedure
Caution: With wheels of the vehicle facing straight ahead, secure the steering wheel utilizing steering column anti-rotation pin, steering column lock, or
a strap to prevent rotation. Locking of the steering column will prevent damage and a possible malfunction of the SIR system. The steering wheel must
be secured in position before disconnecting the following components:
*
The steering column
*
The intermediate shaft(s)
*
The steering gear
After disconnecting these components, do not rotate the steering wheel or move the front tires and wheels. Failure to follow this procedure may cause the
SIR coil assembly to become un-centered and cause possible damage to the SIR coil. If you think the SIR coil has became un-centered, refer to your
specific SIR coil's centering procedure to re-center SIR Coil.
1. Remove the tower brace. Refer to Cross Vehicle Brace Replacement (See: Body and Frame/Frame/Cross-Member/Service and Repair).
2. Secure the steering wheel in place.
3. Remove the lower section of the steering intermediate shaft. Refer to Lower Intermediate Steering Shaft Replacement (See: Steering and
Suspension/Steering/Steering Column/Service and Repair/Removal and Replacement/Lower Intermediate Steering Shaft Replacement).
4. Remove the left and right lower engine mount nuts.
5. Install a screw jack with a block of wood under the oil pan for support.
6. Support the rear of the front frame with a screw jack.
7. Remove the frame rear (1) and center (2) mounting bolts.
8. Loosen the front frame bolts (3) 12.7 mm (0.5 in) to 25.4 mm (1 in).
9. Lower the rear section of the frame.
