CTS Sedan RWD V6-3.0L (2010)
16. Subtract value A from value B. Verify that the resulting measurement is within the specified range.
The rotational torque specification is 0.45-1.35 Nm (4-12 lb in).
17. Repeat the previous steps until you have confirmed that the rotational torque specification is reached, then stake the nut in place. If the rotational
torque requirement has been exceeded, replace the spacer and repeat the steps above.
18. At the correct location, stake the drive flange nut.
19. Install the propeller shaft. Refer to Rear Propeller Shaft Replacement (RPO LSA) (See: Drive/Propeller Shafts, Bearings and
Joints/Drive/Propeller Shaft/Service and Repair)Rear Propeller Shaft Replacement (RPO LLT/LF1with MX7 or MN6) (See: Drive/Propeller
Shafts, Bearings and Joints/Drive/Propeller Shaft/Service and Repair)Rear Propeller Shaft Replacement (RPO LLT, LF1 with MXO) (See:
Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Service and Repair).
20. Lower the vehicle.
