CTS Sedan RWD V6-3.0L (2010)
Shift Linkage: Service and Repair
Shift Rod Replacement
Removal Procedure
1. Remove the shift control assembly. refer to Shift Control Assembly Replacement (See: Shifter M/T/Service and Repair/Tremec 6-Speed - Manual
Transmission/Shift Control Assembly Replacement).
Note: Placing the shift rode close to the transmission housing provides additional support for the shift shaft.
2. Slide the transmission shift rod toward the transmission until the transmission shift shaft seats in the rear most detent position.
3. Using a drift or punch, remove the roll pin (1).
4. Remove the shift rod from the transmission.
Installation Procedure