CTS Wagon AWD V6-3.6L (2010)
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
9. Using a backup wrench on the brake caliper guide pin, install the brake caliper guide pin bolt (1) and tighten to 60 Nm (44 lb ft).
10. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair).
11. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
12. Slowly release the brake pedal.
13. Wait 15 seconds, then repeat steps 11 and 12 until a firm brake pedal apply is obtained. This will properly seat the brake caliper pistons and brake
pads.
14. Fill the brake master cylinder reservoir to the proper level. Refer to Master Cylinder Reservoir Filling (See: Hydraulic System/Brake Master
Cylinder/Service and Repair/Procedures/Master Cylinder Reservoir Filling).
15. Set the electronic park brake cable tension, if equipped. Refer to Parking Brake Cable Adjuster Enabling (Electric Park Brake) (See: Parking
Brake System/Parking Brake Cable/Service and Repair/Procedures/Parking Brake Cable Adjuster Enabling (Electric Park Brake)).
16. Burnish the pads and rotors. Refer to Brake Pad and Rotor Burnishing (See: Brake Pad and Rotor Burnishing).
