CTS Wagon RWD V6-3.6L (2010)
6. Remove the brake hose fitting bolt (1).
7. Remove the brake hose fitting gaskets (2) from the brake hose (3).
Discard the brake hose fitting gaskets.
8. Remove the brake hose.
Installation Procedure
1. Assemble the brake hose fitting bolt (1) with 2 new brake hose fitting gaskets (2) to the brake hose (3).
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the brake hose assembly to the caliper.
Tighten the brake hose fitting bolt to 49 Nm (36 lb ft).