CTS Wagon RWD V6-3.6L (2010)
Parking Brake Actuator: Service and Repair
Parking Brake Actuator Replacement
Removal Procedure
Warning: Refer to Brake Dust Warning (See: Service Precautions/Technician Safety Information/Brake Dust Warning).
1. Block the rear drive wheels.
2. Release the electronic park brake cable tension, if equipped. Refer to Parking Brake Cable Adjuster Disabling (Electric Park Brake) (See:
Parking Brake Cable/Service and Repair/Procedures/Parking Brake Cable Adjuster Disabling (Electric Park Brake)).
3. Turn the ignition to the OFF position.
4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
5. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair
).
6. Remove the parking brake shoes. Refer to Parking Brake Shoe Replacement (See: Parking Brake Shoe/Service and Repair).
7. Disconnect the park brake cable from the actuator.
8. Remove the parking brake actuator (1).
Installation Procedure
