CTS Wagon RWD V6-3.6L (2010)
14. If a new park brake pedal assembly is being installed, the cable tension set pin has to be removed to set the cable tension.
15. To set the park brake cable tension, rotate the pin (1) forward then rotate the pin to the left.
16. Remove the pin.
17. Apply the park brake pedal (2) 3 full cycles to complete the tension set.
18. Install the driver knee bolster. Refer to Driver Knee Bolster Replacement (Left Hand Drive) (See: Body and Frame/Interior Moulding /
Trim/Dashboard / Instrument Panel/Service and Repair/Driver Knee Bolster Replacement)Driver Knee Bolster Replacement (Right Hand Drive)
(See: Application and ID).
19. Install the left instrument panel side trim panel. Refer to Instrument Panel Side Trim Panel Replacement (See: Body and Frame/Interior Moulding
/ Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel Side Trim Panel Replacement).
