CTS Wagon RWD V6-3.6L (2010)
1. Install the ignition coil(s).
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the ignition coil bolt(s) and tighten to 10 Nm (89 lb in).
3. Connect the engine wiring harness electrical connector(s) (5) to the ignition coil(s) (4).
4. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (LP1, LY7) (See: Fuel Delivery and Air Induction/Fuel
Injector/Service and Repair/Fuel Injector Sight Shield Replacement)Fuel Injector Sight Shield Replacement (LLT) (See: Fuel Delivery and Air
Induction/Fuel Injector/Service and Repair/Fuel Injector Sight Shield Replacement).
