CTS Wagon RWD V6-3.6L (2010)
Transmission Position Switch/Sensor: Service and Repair
Vent Hose Replacement
Vent Hose Replacement (Rear Wheel Drive)
Removal Procedure
1. Remove the air inlet housing front panel to gain access to the vent hose upper retainer. Refer to Air Inlet Grille Panel Replacement (See: Body
and Frame/Cowl/Cowl Moulding / Trim/Service and Repair).
2. Remove the vent hose retainer (3) from the rear of the right cylinder head (2).
3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
4. Remove the vent hose retainers (6) located on the transmission support.
5. Support the transmission with a suitable jack.
6. Remove the transmission support. Refer to Transmission Support Replacement (Manual except CTS-V) (See: Body and
Frame/Frame/Cross-Member/Rear Cross-Member/Service and Repair)Transmission Support Replacement (Automatic RWD except CTS-V) (
