CTS Wagon RWD V6-3.6L (2010)
Child Seat Tether Attachment: Service and Repair
Child Restraint Tether Anchor Replacement
Removal Procedure
Warning
Do NOT attempt to repair or alter the bracket on the child seat restraint system. If the bracket is damaged, replace the entire bracket. Altering the bracket
could result in personal injury.
1. Remove the rear shelf panel. Refer to Rear Window Panel Trim Replacement (Sedan) ().
2. Remove the bolt that retains the child tether anchor that is being serviced.
3. Remove the child tether anchor from the vehicle.
Installation Procedure
Note: During installation ensure that the child tether anchors are installed with the anti-rotation tabs firmly seated in the anti-rotation tab holes on the
cross car beam.
1. Install the child tether anchor to the cross car beam.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the child tether anchor bolt and tighten to 30 Nm (22 lb ft).
3. Install the rear shelf trim panel. Refer to Rear Window Panel Trim Replacement (Sedan) ().
