CTS Wagon RWD V6-3.6L (2010)
Transmission Position Switch/Sensor: Service and Repair
Transmission Fluid Cooler Hose/Pipe Replacement (Without VO3)
Transmission Fluid Cooler Hose/Pipe Replacement (Without VO3)
Removal Procedure
1. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement (LF1) (See: Engine, Cooling and Exhaust/Engine/Tune-up and
Engine Performance Checks/Air Cleaner Housing/Service and Repair)Air Cleaner Assembly Replacement (LLT) (See: Engine, Cooling and
Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner Housing/Service and Repair)
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair)
3. Remove the front air deflector. Refer to Front Air Deflector Replacement (See: Body and Frame/Spoilers, Flaps, and Air Dams/Air Dam/Service
and Repair)
4. Remove the front compartment lower noise shield. Refer to Front Compartment Lower Noise Shield Replacement (All Wheel Drive) (See: Body
and Frame/Splash Guard/Service and Repair/Front Compartment Lower Noise Shield Replacement)Front Compartment Lower Noise Shield
Replacement (Rear Wheel Drive) (See: Body and Frame/Splash Guard/Service and Repair/Front Compartment Lower Noise Shield Replacement
)
5. Disconnect the transmission cooler lines (1). Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection
(See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Fluid Line/Hose/Service and Repair)