CTS Wagon RWD V6-3.6L (2010)
5. Install the battery positive lead (2) and the generator BAT terminal nut (3) to the generator and tighten the nut to 13 Nm (115 lb in).
6. Install the BAT terminal boot.
7. Connect the electrical connector (1) to the generator.
8. Install the front air deflector.Refer to Front Air Deflector Replacement (See: Body and Frame/Spoilers, Flaps, and Air Dams/Air Dam/Service
and Repair)
9. Lower the vehicle.
10. Install the drive belt to the generator. Refer to Water Pump and Generator Belt Replacement (See: Engine, Cooling and Exhaust/Engine/Drive
Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair/Water Pump and Generator Belt Replacement).
11. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (Sedan,Wagon) (See: Battery/Battery
Cable/Negative/Service and Repair/Battery Negative Cable Disconnection and Connection).
