CTS Wagon RWD V6-3.6L (2010)
3. Tighten the power steering pump bracket bolts to 50 Nm (37 lb ft).
4. Connect the power steering gear inlet hose fitting to the power steering pump. Refer to Power Steering Gear Inlet Pipe/Hose Replacement (V6,
Left Hand Drive, Rear Wheel Drive) (See: Power Steering Line/Hose/Service and Repair/Power Steering Gear Inlet Pipe/Hose Replacement
)Power Steering Gear Inlet Pipe/Hose Replacement (All Wheel Drive) (See: Power Steering Line/Hose/Service and Repair/Power Steering Gear
Inlet Pipe/Hose Replacement)Power Steering Gear Inlet Pipe/Hose Replacement (Right Hand Drive) (See: Application and ID)Power Steering
Gear Inlet Pipe/Hose Replacement (V8) (See: Power Steering Line/Hose/Service and Repair/Power Steering Gear Inlet Pipe/Hose Replacement).
5. Connect the power steering fluid reservoir outlet hose to the power steering pump.
6. Clean any excess fluid from the vehicle.
7. Remove the drain pans.
8. Install the power steering pump pulley. Refer to Power Steering Pump Pulley Replacement (V8) (See: Power Steering Pump Pulley Replacement
)Power Steering Pump Pulley Replacement (V6) (See: Power Steering Pump Pulley Replacement).
9. Install the front compartment lower noise shield. Refer to Front Compartment Lower Noise Shield Replacement (All Wheel Drive) (See: Body
and Frame/Splash Guard/Service and Repair/Front Compartment Lower Noise Shield Replacement)Front Compartment Lower Noise Shield
Replacement (Rear Wheel Drive) (See: Body and Frame/Splash Guard/Service and Repair/Front Compartment Lower Noise Shield Replacement
).
10. Install the front air deflector. Refer to Front Air Deflector Replacement (See: Body and Frame/Spoilers, Flaps, and Air Dams/Air Dam/Service
and Repair).
11. Fill and bleed the power steering system. Refer to Power Steering System Bleeding (See: Power Steering Bleeding/Service and Repair).
