CTS Wagon RWD V6-3.6L (2010)
4. Inspect for the toe link assembly for loosened jam nuts. In addition, inspect for looseness in the toe link assembly by grasping the adjuster link
using a pull up and pull down method. Perform these procedures on both the rear driver's and passenger's side toe link assembly.
-
If a piece of paper fits between either of the two jam nuts and rear suspension adjustment link (2), replace toe link assembly. Refer to Adjust
Link Replacement in SI.
-
If the toe link assembly has any kind of looseness, replace toe link assembly. Refer to Adjust Link Replacement in SI.
-
If the jam nuts are not loose and the toe link assembly is not loose, proceed to Step 5.
5. Remove and inspect the rear suspension toe link assembly for damage.
1. Hold the rear suspension adjustment link (1) with a 21 mm (13/16 in) open end wrench, and loosen the outside (2) and inside (3) jam nuts.
