CTS Wagon RWD V6-3.6L (2010)
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
6. Install the frame mountings bolts (2) and tighten to 191 Nm (141 lb ft).
7. Install the frame to body bolts (1) and tighten to 250 Nm (180 lb ft)
8. Raise the vehicle.
9. Install the engine mount lower retaining nuts and tighten to 50 Nm (37 lb ft).
10. Remove the J 39580 from under the vehicle.
11. Remove the mechanics wire supporting the power steering gear.
12. Install the shock module yokes to the lower control arms. Refer to Front Shock Absorber Yoke Replacement (See: Suspension Strut / Shock
Absorber/Service and Repair/Front Suspension Strut/Front Shock Absorber Yoke Replacement).
13. Install the power steering gear mounting bolts. Refer to Steering Gear Replacement (Left Hand Drive With All Wheel Drive) (See:
Steering/Steering Gear)Steering Gear Replacement (Left Hand Drive With Rear Wheel Drive) (See: Steering/Steering Gear)Steering Gear
Replacement (Right Hand Drive) (See: Application and ID).
14. Install the ball joint to the steering knuckle. Refer to Lower Control Arm Replacement (AWD) (See: Control Arm/Service and Repair/Front
Suspension)Lower Control Arm Replacement (FWD) (See: Control Arm/Service and Repair/Front Suspension).
15. Install the outer tie rod to the steering knuckle. Refer to Steering Linkage Outer Tie Rod Replacement (All Wheel Drive) (See: Steering/Tie
Rod/Service and Repair/Steering Linkage Outer Tie Rod Replacement)Steering Linkage Outer Tie Rod Replacement (Rear Wheel Drive) (See:
Steering/Tie Rod/Service and Repair/Steering Linkage Outer Tie Rod Replacement).
Note: Ensure correct position from the previously marked spots.
16. Tighten the stabilizer shaft bolts and tighten 65 Nm (48 lb ft).
17. Install the stabilizer shaft link to the lower control arms. Refer to Stabilizer Shaft Link Replacement (AWD) (See: Stabilizer Bar/Stabilizer
Link/Service and Repair/Front Suspension)Stabilizer Shaft Link Replacement (RWD) (See: Stabilizer Bar/Stabilizer Link/Service and
Repair/Front Suspension).
18. Install the brake pressure modulator valve to the bracket. Refer to Brake Pressure Modulator Valve Replacement (CTS) (See: Brakes and
Traction Control/Antilock Brakes / Traction Control Systems/Hydraulic Control Assembly - Antilock Brakes/Service and Repair/Brake Pressure
Modulator Valve Replacement)Brake Pressure Modulator Valve Replacement (CTS-V) (See: Brakes and Traction Control/Antilock Brakes /
Traction Control Systems/Hydraulic Control Assembly - Antilock Brakes/Service and Repair/Brake Pressure Modulator Valve Replacement).
19. Install the brake pipes to the frame.
20. Install the washer bottle bracket to the frame. Refer to Windshield Washer Solvent Container Replacement (With CE4) (See: Wiper and Washer
Systems/Windshield Washer Reservoir/Service and Repair/Windshield Washer Solvent Container Replacement (With CE4))Windshield Washer
Solvent Container Replacement (Without CE4) (See: Wiper and Washer Systems/Windshield Washer Reservoir/Service and Repair/Windshield
Washer Solvent Container Replacement (Without CE4)).
21. Remove the mechanics wire supporting the radiator.
22. Install the wheel speed sensor wire harness to the frame.
