CTS Wagon RWD V6-3.6L (2010)
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the front shock assembly upper mounting bolts and tighten to 112 Nm (83 lb ft).
3. Raise the vehicle.
4. Install the upper control arm to the steering knuckle.
5. Install the upper control arm to steering knuckle retaining nut and tighten to 60 Nm (44 lb ft).
Note: Step 6 is for RWD vehicles only.
6. Install the lower mounting bolts (1) for the shock absorber and tighten to 25 Nm (18 lb ft).
Note: Step 7 is for AWD vehicles only.
7. Install the shock to the shock absorber yoke. Refer to Front Shock Absorber Yoke Replacement (See: Suspension Strut / Shock Absorber/Service
and Repair/Front Suspension Strut/Front Shock Absorber Yoke Replacement).
8. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Wheels and Tires/Service and Repair).
9. Lower the vehicle.
Shock, Shock Component, and/or Spring Replacement
Shock, Shock Component, and/or Spring Replacement
Removal Procedure
Caution: Use care when handling the coil springs in order to avoid chipping or scratching the coating. Damage to the coating will result in
premature failure of the coil springs.
