CTS Wagon RWD V6-3.6L (2010)
Note: Using an approved cleaner, thoroughly clean the threads and allow to dry. Apply threadlocker to the propeller shaft to flange bolt. Ensure
that there are no gaps in the threadlocker along the length of the filled area of the bolt. Allow the threadlocker to cure approximately 10 minutes
before installation.
6. Install the propeller shaft bolts (6), and the washers (5).
7. Install the propeller shaft coupler-to-differential flange nuts (4) and tighten to 85 Nm (63 lb ft).
Note: If reusing the propeller shaft-to-flange nuts and bolts, refer to step 6 for the proper application of the threadlocker.
8. Install the bolts (4), washers (5), and the nuts (6) and tighten to 85 Nm (63 lb ft).
9. Install the floor pan mid tunnel insulator.
10. Install the rear mufflers. Refer to Exhaust System Replacement (LSA) (See: Engine, Cooling and Exhaust/Exhaust System/Service and
Repair/Exhaust System Replacement)Exhaust System Replacement (LF1) (See: Engine, Cooling and Exhaust/Exhaust System/Service and
Repair/Exhaust System Replacement)Exhaust System Replacement (Single) (See: Engine, Cooling and Exhaust/Exhaust System/Service and
Repair/Exhaust System Replacement (Single))Exhaust System Replacement (LLT) (See: Engine, Cooling and Exhaust/Exhaust System/Service
and Repair/Exhaust System Replacement).
11. Lower the vehicle.
