CTS Wagon RWD V6-3.6L (2010)
11. Using the J 42572 - pliers (1), close the inner and outer boot clamps until the gap (a) in the clamp measures 1.0 (0.040 in).
12. Using an alcohol based solvent, remove any lubricant or sealant from the cap and allow to air dry.
13. Apply a 3 mm (0.118 in) bead of the sealant on the inside diameter of the of the CV joint face. Refer to Adhesives, Fluids, Lubricants, and Sealers
(See: Specifications/Fluid Type Specifications).
14. For the CTS proceed to step 15. For the CTS-V, proceed to step 16.
15. Using the J 22928-B - installer (1) and a hammer, install the grease cap (2) on the inner housing.
