CTS Wagon RWD V6-3.6L (2010)
13. Tighten the shift assembly clamp bolt (1) to 30 Nm (22 lb ft)
14. Remove the alignment pin (1) from the rear of the shifter assembly, then install in service storage position.
15. Install rubber grommet covering alignment hole.
16. Install the 4 fasteners (1) securing the shift control adapter plate to the tunnel reinforcements, then tighten the bolts to 12 Nm (106 lb in).
17. Install the 4 fasteners (2) securing the shift control assembly to the shift control adapter plate, then tighten the fasteners to 18 Nm (13 lb ft)
