CTS Wagon RWD V6-3.6L (2010)
Installation Procedure
1. Install the shift control linkage to the vehicle.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the manual shift shaft nut and tighten to 15 Nm (11 lb ft).
3. Connect the shift control linkage rod to the shift control assembly.
4. Install the nut to the shift control linkage rod.
5. Adjust the shift control linkage. Refer to Shift Control Linkage Adjustment (All Wheel Drive) (See: Shift Control Linkage Adjustment)Shift
Control Linkage Adjustment (Rear Wheel Drive) (See: Shift Control Linkage Adjustment).
6. Lower the vehicle.
