CTS Wagon RWD V6-3.6L (2010)
3. Install the prop shaft flange.
Caution: Stake the flange nut onto the output shaft. Use the two staking grooves on the shaft to locate the staking points. Failure to stake the
flange nut may result in damage to the transmission.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
Note: Use a NEW propeller shaft flange nut.
4. Install the NEW propeller shaft flange nut and tighten to 105 Nm (77 lb ft).
5. Remove the propeller shaft flange holding fixture J 45012 .
6. Install the transmission mount assembly. Refer to Transmission Mount Replacement (Except AWD and CTS-V) (See: Transmission Mount
Replacement)Transmission Mount Replacement (CTS-V) (See: Transmission Mount Replacement)Transmission Mount Replacement (Automatic
AWD) (See: Transmission Mount Replacement).
7. Remove the transmission jack.
8. Install the drive shaft. Refer to Rear Propeller Shaft Replacement (RPO LSA) (See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller
Shaft/Service and Repair)Rear Propeller Shaft Replacement (RPO LLT/LF1with MX7 or MN6) (See: Drive/Propeller Shafts, Bearings and
Joints/Drive/Propeller Shaft/Service and Repair)Rear Propeller Shaft Replacement (RPO LLT, LF1 with MXO) (See: Drive/Propeller Shafts,
Bearings and Joints/Drive/Propeller Shaft/Service and Repair).
9. Install the exhaust system. Refer to Exhaust System Replacement (LSA) (See: Engine, Cooling and Exhaust/Exhaust System/Service and
Repair/Exhaust System Replacement)Exhaust System Replacement (LF1) (See: Engine, Cooling and Exhaust/Exhaust System/Service and
Repair/Exhaust System Replacement)Exhaust System Replacement (Single) (See: Engine, Cooling and Exhaust/Exhaust System/Service and
Repair/Exhaust System Replacement (Single))Exhaust System Replacement (LLT) (See: Engine, Cooling and Exhaust/Exhaust System/Service
and Repair/Exhaust System Replacement).
10. Lower the vehicle.
