CTS Wagon RWD V6-3.6L (2010)
access hole in the engine block.
2. To aid in alignment of the torque converter to the flexplate/flywheel. Install all NEW torque converter bolts before fully tightening to 63 Nm
(46 lb ft).
12. Remove the starter motor. Refer to Starter Replacement (LF1/LLT) (See: Starting and Charging/Starting System/Starter Motor/Service and
Repair)Starter Replacement (LSA) (See: Starting and Charging/Starting System/Starter Motor/Service and Repair).
13. Install the transmission close out plug (1).
14. Place NEW O-rings over the transmission fluid cooler pipes.
15. Install the transmission fluid cooler pipes (1) to the transmission. Refer to Transmission Fluid Cooler Hose/Pipe Replacement (With VO3) (See:
Transmission Fluid Cooler Hose/Pipe Replacement (With VO3))Transmission Fluid Cooler Hose/Pipe Replacement (Without VO3) (See:
Transmission Fluid Cooler Hose/Pipe Replacement (Without VO3)).
