CTS Wagon RWD V6-3.6L (2010)
Front Door Window Glass: Service and Repair
Front Side Door Window Replacement (Sedan/Wagon)
Removal Procedure
1. Run the window to the full closed position.
Warning: Refer to Glass and Sheet Metal Handling Warning (See: Body and Frame/Service Precautions/Glass and Sheet Metal Handling
Warning).
Warning: Refer to Express Window Down Warning (See: Service Precautions).
2. Remove the door trim panel. Refer to Front Side Door Trim Panel Replacement (See: Body and Frame/Doors, Hood and Trunk/Doors/Front
Door/Front Door Panel/Service and Repair).
3. Remove the water deflector.
4. Remove the window inner belt sealing strip. Refer to Front Side Door Window Belt Inner Sealing Strip Replacement (Sedan/Wagon) (See:
Service and Repair/Front Side Door Window Belt Inner Sealing Strip Replacement).
5. Tape the window in the closed position.
6. Loosen the window regulator clamp fasteners.
7. Connect the door trim panel electrical connector.
8. Using the power window switch, lower the window regulator to separate the window from the clamps.
9. Remove the tape.
10. Remove the window by tilting the window forward, pull the window up and out of the door.
Installation Procedure
Note: The window regulator should be at least 1/2 way down before installing the window.
1. Install the window into the door.
2. Position the window into the two window regulator clamps.
Note: Start the vehicle to ensure maximum power to the window motor. This is required in order to fully seat the window for adjustment.
3. Start the vehicle.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
4. Using the power window switch, raise the window to the fully closed position. Tighten the window clamp fasteners to 11 Nm (98 lb in).
5. Install the window inner belt sealing strip. Refer to Front Side Door Window Belt Inner Sealing Strip Replacement (Sedan/Wagon) (See: Service
and Repair/Front Side Door Window Belt Inner Sealing Strip Replacement).
