DeVille V8-273 4.5L (1989)
Front Door Panel: By Symptom
Technical Service Bulletin # 903010
Date: 891201
Door Trim Panel - Warping
Bulletin Number
T-90-30
File in Group
10
Number
164
Corp. Ref. No.
911516
Date
Dec. 1989
SUBJECT:
DOOR TRIM PANEL WARPING AT BELT LINE
MODELS AFFECTED: 1989-1990 FLEETWOODS
Some 1989-1990 Fleetwoods may experience a condition where the door trim panel may warp away from the chrome molding at the belt line. This
condition may be caused by too much foam at the top edge of the door trim pad or improper installation. To repair this condition use the following
procedure:
Figure 1 - Marking Hole Position
1.
Remove the upper section of the door trim panel.
2.
Measure down from top of door trim panel at least 1-1/2 inches, or on severely bowed door trim panels mark hole position just above crease line
on the backside of the panel. Refer to Figure 1.
Figure 2 - Plastic Fastener
