DeVille V8-4.6L VIN 9 (1995)
2. Measure lower inner corner of wheelhouse extension to be cut as shown with dotted line in Figure 2. The corresponding cut-out dimensions for each
body style of vehicle to be modified are listed in the chart following:
3. Remove upper inboard fastening screw.
4. Loosen the lower inboard bolt, but do not remove.
5. Cut and remove marked area of wheelhouse extension using a utility knife or equivalent.
6. Reposition wheelhouse extension by pushing forward and upward. With extension repositioned, tighten the lower inboard bolt.
7. Check upper screw hole for alignment. If hole alignment is off, remove the wheel assembly and drill new hole. The old hole must be filled with a
suitable filler.
8. Reinstall upper inboard screw.
9. If removed, install wheel assembly and torque to specification.
10. Lower vehicle.
Warranty Information
For vehicles repaired under warranty.
