DeVille V8-4.6L VIN 9 (1995)
20. Remove the water crossover from the engine.
INSTALLATION PROCEDURE
1. Install the water crossover on the engine.
TIGHTEN
-
Water crossover bolts to 25 Nm (18 lb ft).
NOTICE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners
requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use
paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint
clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid
damage to parts and systems.
2. Install the water pump cover.
TIGHTEN
-
Water pump cover to 10 Nm (89 lb in).
3. Connect the park neutral switch.
4. Connect the EGR pipe to the water crossover.
5. Install the EGR.
6. Install the throttle body spacer.
