DeVille V8-4.6L VIN 9 (1995)
^
Remove the blower motor screws (either 3 or 5 screws).
^
Remove the blower motor from the HVAC Module.
Installation Procedure
1.
If present, remove the 2 ribs located on the barrier. Refer to Step 3 and the illustrations in the Instruction Sheet, P/N, 52494110, found in the
blower motor kit.
Important:
Ensure the blower motor gasket makes a complete seal around the blower motor.
2.
Install the new blower motor with heat shield. Refer to Steps 4 and 5 in the Instruction Sheet, P/N 52494110, found in the blower motor kit.
3.
Install the blower motor retaining screws.
Tighten
Tighten the screws to 4 N.m (35 lb in).
4.
Tighten the lower heat shield retaining screws to 4 N.m (35 lb in).
5.
Connect the connector to the blower motor.
6.
Install the solenoid purge valve.
7.
Reposition and connect the ignition control module assembly.
8.
Install the cross-car brace.
9.
Connect the negative battery cable.
Eldorado/Seville-HVAC Blower Motor
Caution:
Before servicing any electrical component, the ignition key must be in the OFF or LOCK position and all electrical loads must be OFF, unless
instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also disconnect
the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components.
Removal Procedure
1.
Disconnect the negative battery cable.
2.
Remove the camshaft cover.
3.
Remove the blower motor.
^
Disconnect connector from the blower motor.
^
Remove the blower motor screws (either 3 or 5 screws).
^
Remove the blower motor from the HVAC Module.
Installation Procedure
1.
If present, remove the 2 ribs located on the barrier. Refer to Step 3 and the illustrations in the Instruction Sheet, P/N 52494110, found in the
blower motor kit.
Important:
Ensure the blower motor gasket makes a complete seal around the blower motor.
2.
Install the new blower motor with heat shield. Refer to Steps 4 and 5 in the Instruction Sheet, P/N 52494110, found in the blower motor kit.
3.
Install the blower motor retaining screws.
