DeVille V8-4.6L VIN 9 (1995)
6. Fuel tank. Refer to Fuel Tank Replacement.
7. Section of pipe to be replaced.
INSTALL OR CONNECT
CAUTION: To Reduce the Risk of Fire and Personal Injury:
^
If nylon fuel pipes are nicked, scratched or damaged during installation, they must be replaced.
^
When installing new fuel pipes, Do Not hammer directly on the fuel harness body clips as it may damage the nylon pipes resulting in a possible
fuel leak.
^
Before connecting fuel pipe fittings, always apply a few drops of clean engine oil to the male pipe ends. This will ensure proper reconnection
and prevent a possible fuel leak. (During normal operation, the O-rings located in the female connector will swell and may prevent proper
reconnection if not lubricated.)
1. Position new fuel pipe in original location.
2. Remove protective caps from fuel pipe.
3. Apply a few drops of clean engine oil to the male connector pipe end.
4. Quick-connect fitting at fuel sender.
a. Push connector together to cause the retaining tabs/fingers to snap into place.
b. Once installed, pull on both ends of connection to make sure connection is secure.
5. Fuel tank. Refer to Fuel Tank Replacement.
6. Retaining hardware.
7. Repeat connect procedure for fuel filter fuel pipe quick-connect fitting.
8. Lower vehicle.
9. Tighten fuel filler cap.
10. Negative battery terminal.
INSPECT
Turn ignition switch to 'ON' position for two seconds, then turn to 'OFF' for five seconds. Again, turn to 'ON' position and check for fuel leaks.
