DeVille V8-4.6L VIN 9 (1995)
16.
Inspect the SDM for the presence of potting compound (clear sealer) at the locations shown in figure 5.
If potting compound is present at the locations indicated in figure 5, proceed to step # 19 of this service procedure.
If potting compound is not present, proceed to step # 17 of this service procedure.
NOTICE:
THE AREAS TO BE SEALED MUST BE THOROUGHLY CLEANED WITH A SCOTCH BRITE(R) PAD BEFORE APPLYING THE
POTTING COMPOUND. FAILURE TO PROPERLY CLEAN AND PREPARE THE SURFACES TO SE SEALED MAY RESULT IN AN
INEFFECTIVE SEAL, WHICH COULD ALLOW WATER TO ENTER THE SDM CASE. IF WATER ENTERS THE SDM CASE, AN
UNWANTED AIR BAG DEPLOYMENT COULD OCCUR.
17.
Thoroughly clean the exterior of the SDM case using the 3M Scotch Brite(R) pad provided. Pay careful attention to the areas where potting
compound will be applied, so that the potting compound can bond to a clean surface. If necessary, carefully remove any light oxidation/corrosion
from the case. Using a clean shop cloth, carefully remove any cleaning residue from the surface of the SDM case.
18.
For controlled flow of potting compound, cut off the tip of one of the applicator tips to provide the smallest possible opening (approximately 2 mm
inner diameter). Carefully apply Loctite 5140(R) potting compound as shown in figure 5 per the following instructions:
NOTICE:
DO NOT ALLOW POTTING COMPOUND TO CONTACT THE PINS IN THE CONNECTOR BODY. ALSO, MAKE SURE THAT THE
