DeVille V8-4.6L VIN 9 (1995)
struts to the firm mode when the switch senses lateral acceleration.
Each actuator provides a feedback voltage signifying the actuator position relative to a Home position. A single 3-volt pad signifies the home
position which correlates to the first comfort damping position of the actuator, while subsequent zero to 1-volt pads signify the remaining damping
positions. Each damping position is separated by a 5-volt pad.
SSS Error Lamp
ERROR LAMP
When the ignition switch is turned on the system performs a self test which lasts for 7.5 seconds. The error lamp will be on for this period. After the self
test, the control module may be in one of the following modes:
Normal operating mode - the error lamp is on below 10 mph and goes off above 10 mph to indicate proper operation of the SSS system and to verify
that the control module is receiving speed information.
Error mode - the error lamp is off below 10 mph and turns on above 10 mph.
Reset Mode - the error lamp is turned off to indicate a SSS control module problem.
Any system error will cause a "SERVICE RIDE CONTROL" message to be displayed on the Driver Information Center (except for the Accelerometer
Error Code 32 which is flagged immediately). The message will be displayed as long as the error code is active. If the fault corrects itself, the "SERVICE
RIDE CONTROL" message will turn off, but the error code will be retained in the control module memory.
Error codes are stored in the control module in non-volatile memory. In diagnostics, the error codes are read via the L.E.D. by grounding the Diagnostic
Enable circuit and counting the L.E.D. flashes.
If a code is set, a one second self diagnostic test is performed at three minute intervals. The error lamp will be on during this test and will go out if the
fault is corrected. If the fault still exists, the lamp will be off below 10 mph and on above 10 mph.
