DeVille V8-4.6L VIN 9 (1995)
REMOVE
1. Trunk front trim panel.
2. Electrical connectors from RSS control module.
3. RSS Control Module from right electronics bay.
INSTALL
1. RSS Control Module to right electronics bay.
2. Electrical connectors to RSS control module.
3. Trunk front trim panel.
Note
After replacing RSS control module, the following must be performed:
^
Trim Height Adjustment.
Vehicle Trim Height Adjustment
VEHICLE TRIM HEIGHT
1. Vehicle must be on a level surface, doors closed, with no passengers or extra weight in car.
2. If any RSS rear position or rear damper codes are set, they must be repaired before performing trim height adjustment procedure.
3. Check rear position sensor values in diagnostics (RTD Data Parameters SD13 and SD14) to be sure they are within normal value ranges. If not,
check for bent position sensor brackets or disconnected sensors.
4. Check fuel level reading in IPC (Data Parameter ID40) and round up to the nearest gallon (example, 12.1 gallons rounds up to 13 gallons).
5. Connect Tech 1 to Data Line Connector (DLC).
6. Key on, engine off.
IMPORTANT: Do not sit in vehicle while performing trim set procedure.
7. Proceed per instructions on Tech 1 readout.
8. When complete, remove Tech 1 from vehicle.
