DeVille V8-4.6L VIN 9 (1995)
stations and the clock.
1992 Eldorado and Seville with Speed Sensitive Suspension (SSS)
Refer to the Service Manual page, 8C1-11. Observe and record the IPC override "IS08" displayed value. Use the climate control "cooler" button to
decrease the value displayed for "IS08" by "8". To store the new value, press and hold the "ECON" and "FRONT DEFROST" keys until the new value
flashes on and off.
1993 Eldorado and Seville with Speed Sensitive Suspension and 4.9L Engine Only
Refer to page 8A-43-6 in the 1992 Eldorado Seville Service Manual.
1. Cut circuit 1020 (PINK).
2. Attach the IPC side of circuit 1020 to relay pin 87A.
3. Attach the module side of circuit 1020 to relay pin 86.
4. Run a ground wire to relay pin 30.
5. Run a wire from a switched ignition (hot in Run) source to relay pin 85.
1991-1993 DeVille with Computer Command Ride (CCR)
Refer to the Service Manual, page 8A-43-0. Cut Circuit 1300 (Dark Green wire) at the CCR module (Pin C15) to disable the indicator lamp. Tape the
wires back into the harness to prevent shorting to other components.
1994-1995 DeVille with Speed Sensitive Suspension (SSS) and 4.9L Engines Only
Refer to the 1994 Eldorado, Seville, DeVille Service Manual, page 8A-43-14.
1. Locate and cut circuit 370 (RED).
2. Attach the IPC side of circuit 370 to pin 87A of the relay.
3. Attach the module side of circuit 370 to pin 86 of the relay.
4. Run a ground wire to relay pin 30.
5. Run a wire from a switched ignition (hot in Run) source to relay pin 85.
1992-1993 Oldsmobile Achieva with Computer Command Ride (CCR)
This is a stand alone system. Remove the CCR module which is attached to the back side of the right (passenger side) sound insulator panel. Follow the
wiring harness up under the dash assembly and then cut and tape the wiring harness.
1992-1994 Buick Skylark with Computer Command Ride (CCR)
This is a stand alone system. Remove the CCR module which is attached to the back side of the right (passenger side) sound insulator panel. Follow the
wiring harness up under the dash assembly and then cut and tape the wiring harness.
1993-1996 Buick Park Avenue with Computer Command Ride (CCR)
This is a stand alone system. Remove the CCR module, which is located under the carpeting beneath the driver's seat.
1991-1995 Oldsmobile Ninety Eight with Computer Command Ride (CCR)
This is a stand alone system. Remove the CCR module, which is located under the carpeting beneath the driver's seat.
1994-1999 Pontiac Bonneville with Computer Command Ride (CCR)
The feedback strut/shock assemblies are still available for these vehicles. However, if the customer desires to reduce the repair expense, the following
steps may be taken to allow installation of non-feedback assemblies and the disabling of the malfunction indicator lamps.
This is a stand alone system. Remove the CCR module, which is located under the carpeting beneath the driver's seat.
Parts Information
