DeVille V8-4.6L VIN Y (1998)
Keyless Entry Receiver: Service and Repair
REMOVAL PROCEDURE
1. Remove the rear electronic bay board.
2. Disconnect the wiring harness connection.
3. Press on the locking tabs in order to remove the remote function actuator (RFA) module (1) from the left side of the electronics bay board.
INSTALLATION PROCEDURE
1. Install the remote function actuator (RFA) (1) module onto the electronics bay board.
2. Connect the wiring harness connection.
3. Install the rear electronic bay board.
4. Reprogram the transmitters. Refer to Transmitter Synchronization. See: Keyless Entry Transmitter/Service and Repair
