DeVille V8-4.6L VIN Y (1998)
8.1.
With the harness side to the factory element (6), insert the modified service element (7) between the leather trim cover (5) and the existing
factory heat element (6).
8.2.
Ensure the service element is laying flat, is tucked into each corner and extends to each side.
8.3.
Remove the backing paper from the adhesive tape.
8.4.
Place the two heat elements between your hands and apply pressure.
8.5.
Use 3M(R) Highland Cloth Duct Tape, P/N 06969, or equivalent, to cover the opening.
9.
Attach the seat back assembly to the seat cushion assembly.
^
Install the hinge bolts.
^
Install the roll pins that retain the reclining actuator to the seat back hinge.
^
Connect the electrical connectors between the seat back and the seat cushion.
10.
Place the seat assembly inside the vehicle and connect the electrical connectors. DO NOT install at this time.
11.
Verify the seat heat function is operational.
12.
Complete the seat assembly installation. Refer to Seat Replacement in the Seats sub-section of the appropriate Service Manual for the installation
procedure.
