DeVille V8-4.6L VIN Y (1998)
5.
Use scissors to remove approximately 19 mm (3/4 in) of material (a) from around the cushion thigh heat element (3). (Back Cushion Upper heat
element similar.)
6.
Check for proper fit.
6.1.
With the harness side to the factory element, insert the harness through the small opening and place the service element between the leather
trim cover and the existing factory heat element.
6.2.
Ensure the element is laying flat is tucked into each corner and extends to each side.
6.3.
It may be necessary to remove additional material.
7.
On the harness side, place two 20 cm (8 in) vertical strips of double sided tape (4) such as 3M(R) Scotch Adhesive Transfer Tape, P/N 06494, or
equivalent, onto the modified service heat element. DO NOT REMOVE the backing paper at this time.
Important:
To ensure customer comfort and satisfaction, it is important the service heat element extends to each side and lays flat.
8.
Install the modified service heat element.
8.1.
With the harness side to the factory element, insert the modified service element between the leather trim cover and the existing factory heat
element.
8.2.
Ensure the service element is laying flat, is tucked into each corner and extends to each side.
8.3.Remove the backing paper from the adhesive tape.
8.4.
Place the two heat elements between your hands and apply pressure.
8.5.
Use 3M(R) Highland Cloth Duct Tape, P/N 06969, or equivalent, to cover the opening.
