cadillac Workshop Repair Guides

Cadillac Workshop Service and Repair Manuals

All Other Service Bulletins for Brake Pad: > < 99-05-23-004|Page 8369
Page 1
background image

Brake Pad: All Technical Service Bulletins
Brakes - Grunt/Groan/Grind/Crunch/Squeal From Front

File In Section: 5 - Brakes

Bulletin No.: 73-50-23A

Date: January, 1998

Subject: 
Brake Noise (Grunt/Groan/Grind/Crunch/Squeal) Coming from Front Brakes (Replace Front Brake Pads/Rotors)

Models: 
1997-98 Buick Riviera, Park Avenue
1997-98 Cadillac Concours, DeVille, Eldorado, Seville
1997-98 Oldsmobile Aurora
1998 Models Affected Were Built Prior to November 1, 1997

This bulletin is being revised to update the model years affected and to include replacement of the brake rotors. Please discard Corporate Bulletin
Number 73-50-23 (Section 5 - Brakes).

Condition

Some owners may comment on a grunt, groan, grind, crunch or squeal noise coming from the front brakes when applying the brakes at low speeds (35
mph - 0 mph).

Important

The previous bulletin number (73-50-30) instructed to replace the front brake pads. Owners of vehicles that were serviced under the original bulletin
guidelines may now comment on a squeal noise after the brake pads were replaced.

Correction

For 1997 vehicles that have not been previously serviced for the grunt, groan, grind or crunch condition, replace the front brake pads and rotors with new
brake pads, P/N 18024961, and brake rotors, P/N 18026591.

For vehicles that have been previously serviced for these various noise conditions and now exhibit a squeal condition, replace the brake rotors only with
the larger 8 mm (0.32 in.) cheek rotors, P/N 18026591.

For 1998 vehicles built prior to November 1, 1997, measure the rotor cheek to verify the size of the rotors on that vehicle. Vehicles produced after
approximately November 1, 1997, will be built with the larger 8 mm (0.32 in.) cheek rotors and the updated brake pads and should not exhibit the above
conditions. To achieve the proper rotor measurement, measure only one side of the rotor from the cooling fin area to the outer braking surface (measure
only 1 rotor check). The old design rotors have 6 mm (0.24 in.) cheeks. The new design rotors have 8 mm (0.32 in.) cheeks.

Parts Information

Parts are currently available from GMSPO.

Warranty Information

For vehicles repaired under warranty, use the table.

All Other Service Bulletins for Brake Pad: > < 99-05-23-004|Page 8369