DeVille V8-4.6L VIN Y (1998)
8. Remove the front insulator and insulator mounting bolt.
9. Remove the four EBTCM to BPMV bolts.
CAUTION: Do not pry the EBTCM from the BPMV as damage to the seal may result.
10. Separate the EBTCM from the BPMV by gently pulling forward until separated. Be careful not to damage the seal.
11. Clean the seal and BPMV gasket surface with alcohol.
INSTALLATION PROCEDURE
1. Install the EBTCM to the BPMV.
NOTICE: Refer to Service Precautions.
2. Install the four mounting bolts.
^
Tighten the four mounting bolts to 5 Nm (40 inch lbs.).
3. Install the insulator bolt.
^
Tighten the insulator bolt to 14 Nm (10 ft. lbs.).
IMPORTANT: If a new BPMV is being installed, remove the shipping plugs from the valve openings.
4. Position the EBTCM/BPMV assembly in the bracket and install insulators and bracket nuts.
5. Install the bracket nuts.
^
Tighten the bracket nuts to 10 Nm (89 inch lbs.).
