DeVille V8-4.6L VIN Y (1998)
Wheel Fastener: Service and Repair
REMOVAL
^
Tool Required:
-
J 6627-A Wheel Stud Remover
1. Raise and support the vehicle.
2. Remove the tire and wheel assembly.
3. Suspend the caliper.
4. Remove the rotor.
5. Remove the wheel stud (2) with the J 6627-A.
INSTALLATION
1. Install the wheel stud.
2. Install the rotor.
3. Install the caliper and new caliper mounting bracket bolts.
^
Tighten the caliper mounting bracket bolts to 113 Nm (83 ft. lbs.).
^
Tighten the parking brake cable bracket bolt to 43 Nm (43 ft. lbs.).
NOTICE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners
requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion
inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
4. Install the tire and wheel assembly.
5. Lower the vehicle.
