DeVille V8-4.6L VIN Y (1998)
17. Separate the two banana plugs on the SIR deployment harness.
IMPORTANT: The rapid gas expansion involved with deploying an air bag is very loud. Notify all the people in the immediate area that you intend to
deploy the inflator module.
IMPORTANT: When the air bag deploys, the inflator module may jump about 30 cm (1 ft) vertically. This is a normal reaction of the inflator module
to the force of the rapid gas expansion inside the air bag.
18. Connect the SIR deployment harness wires to the power source.
19. Disconnect the SIR deployment harness from the power source after the air bag deploys.
20. Seat one banana plug into the other in order to short the deployment harness leads.
21. If the air bag did not deploy, disconnect the adapter and discontinue the procedure. Contact the Technical Assistance Group. Otherwise, proceed to
the following steps.
CAUTION: Immediately following the deployment of an air bag, the metal surfaces of the inflator module are very hot. Do not place the
deployed inflator module near any flammable objects. Wait for about ten minutes before touching any metal surface of the inflator module.
Disregarding these precautions may cause fire or personal injury.
