DeVille V8-4.6L VIN Y (1998)
3.
Remove the fasteners attaching the SISM to the door panel and remove the SISM.
4.
Install a new SISM to the door panel and install the fasteners. Tighten to 9 Nm (80 lb.in.).
5.
Connect the electrical connector to the SISM and install the CPA.
6.
On the driver's door, remove the CPA and disconnect the electrical connector from the Side Impact Sensing Module (SISM).
7.
Remove the fasteners attaching the SISM to the door panel and remove the SISM.
8.
Install a new SISM to the door panel and install the fasteners. Tighten to 9 Nm (80 lb.in.).
9.
Connect the electrical connector to the SISM and install the CPA.
10.
Enable the SIR system.
^
On vehicles that DID have the temporary disconnect installed, remove any electrical tape that may be remaining on the driver's door air bag
module electrical connector.
^
Connect the driver's door air bag module connector to the electrical connector going to the SISM and install the CPA.
^
Connect the electrical connector for the driver's door speaker and install the door trim panel.
^
Connect the electrical connector for the driver's door courtesy light and install the courtesy light.
^
Install the driver's door switch plate.
^
Connect the electrical connector for the driver's door handle bezel and install the bezel.
^
On vehicles that DID have the temporary disconnect installed, remove any electrical tape that may be remaining on the passenger door air bag
module electrical connector.
^
Connect the passenger door air bag module connector to the electrical connector going to the SISM and install the CPA.
^
Connect the electrical connector for the passenger door speaker and install the door trim panel.
^
Connect the electrical connector for the passenger door courtesy light and install the courtesy light.
^
Install the passenger door switch plate.
^
Connect the electrical connector for the passenger door handle bezel and install the bezel.
^
Reconnect the passenger side air bag electrical connector and install the CPA. Install the passenger side instrument panel insulator panel.
^
Reconnect the driver's side air bag electrical connector at the base of the steering column and install the CPA.
^
Install the driver's side instrument panel insulator panel.
^
Install the SIR fuse in the rear compartment fuse panel.
11.
Insert the key and turn the ignition switch to the "ON" position and verify that the AIR BAG light flashes seven (7) times and goes out.
12.
On vehicles that DID have the temporary disconnect installed, remove the temporary disconnect label from the driver's door opening.
13.
Install the GM Campaign Identification Label.
CAMPAIGN IDENTIFICATION LABEL - For US and IPC
Place a Campaign Identification Label on each vehicle corrected in accordance with the instructions outlined in this Product Campaign Bulletin. Each
label provides a space to include the campaign number and the five (5) digit dealer code of the dealer performing the campaign service. This information
may be inserted with a typewriter or a ball point pen.
