DeVille V8-4.6L VIN Y (1998)
3. Install the ball joint to control arm bolts.
^
Tighten the ball joint to control arm nuts (5) to: 68 Nm (50 ft. lbs.).
^
Tighten the ball joint nut (2) to 10 Nm (84 inch lbs.) using J 35551 90 ° to torque wrench. Tighten the nut an additional 120 °. When
tightening the nut a minimum torque of 50 Nm (37 ft. lbs.) must be obtained. If 50 Nm (37 ft. lbs.) is not obtained, inspect the ball joint for
stripped threads. If threads are satisfactory, replace the ball joint and knuckle. If required, turn the nut up to an additional 60 ° in order to allow
for the installation of the cotter pin (1).
4. Install the Road Sensing Suspension position sensor to lower control arm.
5. Install the tire and wheel assembly.
^
Tighten the wheel nuts to: 140 Nm (100 ft. lbs.).
6. Lower the vehicle.
