DeVille V8-4.6L VIN Y (1998)
9. Remove the nut (1) form the backside of the knuckle.
10. Using a press, press the hub from the knuckle.
11. Remove the hub from the knuckle.
12. Remove the brake backing plate from the knuckle.
13. If required, press the bearing from the knuckle.
INSTALLATION
1. Press the bearing into the knuckle if required.
NOTICE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners
requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion
inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
2. Install the bearing retainer and four bolts to the knuckle.
^
Tighten the backing plate bolts to 50 Nm (37 ft. lbs.).
3. Press the hub into the bearing.
4. Install the speed sensor reluctor and nut (1).
^
Tighten the nut to 200 Nm (145 ft. lbs.).