DeVille V8-4.6L VIN Y (1998)
Road Surface Sensor: Service and Repair
Front RSS Position Sensor
REMOVAL
1. Raise the vehicle.
2. Remove the wheel from the vehicle.
3. Disconnect the sensor harness connector from the vehicle harness connector.
4. Disconnect the sensor harness clips from the vehicle at two places.
5. Disconnect the sensor link from the ball stud.
Front
6. Remove the two screws and position sensor from the vehicle.
INSTALLATION
NOTICE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners
requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion
inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
