DeVille V8-4.6L VIN Y (1998)
8. Disconnect the Anti-Lock Brake System (ABS) wheel speed sensor connector from the hub and bearing assembly.
9. Remove the wheel bearing and hub.
INSTALLATION
1. Connect the ABS wheel speed sensor connector to the hub and bearing assembly.
NOTICE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners
requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion
inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
2. Connect the hub and bearing assembly to the knuckle.
^
Tighten the hub and bearing retaining bolts to 95 Nm (70 ft. lbs.)
3. Install the rotor.
4. Install the caliper and support the caliper by using new caliper mounting bolts.
5. Install the drift punch into the rotor and partially tighten the hub nut and washer.
6. Install the tire and wheel assembly.
^
Tighten wheel nuts to: 140 Nm (100 ft. lbs.).
7. Lower the vehicle.
^
Tighten the hub nut to: 145 Nm (110 ft. lbs.).
