DeVille Concours V8-4.6L VIN Y (1995)
Door Lock Actuator
NOTICE: Before installing new actuator (1), lock assembly (2) must be in full open position (9) and teeth (13) on lock switch (14) (part of the
actuator) must be pushed fully toward actuator arm (11) to prevent damage to lock switch when lock assembly is operated.
1. Release lock assembly (2) to be sure it is in full open position (9). Do this by pushing upon outside lock rod lever (8) and then pulling on inside
lock handle lever (4).
2. Before placing new actuator on lock assembly, you must first position plastic teeth of lock switch. Push teeth (13) fully toward actuator arm (11)
so they will mesh correctly with teeth on lock assembly when installed.
3. Verify that actuating arm rubber bumper (10) is on actuating arm (11). Install actuating arm and bumper into locking lever (12), align lock switch
teeth to gear tooth forkbolt (15) and align screw holes.
