DeVille Concours V8-4.6L VIN Y (1995)
20.
Unclip the fuel lines from the retainers.
21.
Disconnect the fuel feed line at the quick connect on the rearward end of the fuel filter (5).
22.
Disconnect the remaining two lines at the quick connects rearward (6) of the fuel filter.
23.
Remove the fuel lines and all retainers from the vehicle.
Important
Do NOT bend the new fuel lines when installing in the next step.
24.
Position the NEW fuel lines under the vehicle and route the engine end of the lines up into the engine compartment.
25.
Install the new fuel lines and retainers to the floor pan.
Caution
In order to reduce the risk of fire and personal injury, before connecting fuel pipe fittings, always apply a few drops of clean engine oil to the
male pipe ends. This will ensure proper reconnection and prevent a possible fuel leak. During normal operation, the 0-rings located in the
female connector will swell and may prevent proper reconnection if not lubricated.
26.
Apply a few drops of clean engine oil to the male ends of the quick connect pipes.
27.
Install the NEW fuel filter to the fuel line and quick connect fitting. Push both sides of the fitting together to cause the retaining tabs/fingers to
snap into place.
Tighten the flare nut to 30 Nm (22 lb ft).
28.
Connect the remaining quick-connect fittings under the vehicle. Push both sides of the fittings together to cause the retaining tabs/fingers to snap
into place.
29.
Pull on both sides of all quick-connect fittings to ensure connections are secure.
30.
Install the fuel lines to the retainer. Position the retainer to the lower cowl sheet metal and install the bolt.
Tighten the bolt to 9 Nm (7 lb ft).
31.
Position the brace between the body rail and the lower cowl sheet metal. Install the four bolts.
Tighten to 50 Nm (37 lb ft).
32.
Raise the rear of the engine cradle and install the four bolts.
Tighten to 100 Nm (74 lb ft).
33.
Install the two nuts attaching the left side transmission bracket to the body mount.
Tighten to 35-45 Nm (47-61 lb ft).
34.
Position the left front wheelhouse liner and install the seven push-in retainers.
35.
Install the left front tire and wheel.
Tighten the nuts to 140 Nm (100 lb ft).
36.
Lower the vehicle.
37.
Connect the electrical connector to the ABS module.
38.
Position the ABS module to the left strut (shock) tower and install the two nuts.
Tighten to 11 Nm (96 lb in).
Caution
In order to reduce the risk of fire and personal injury, before connecting fuel pipe fittings, always apply a few drops of clean engine oil to the
male pipe ends. This will ensure proper reconnection and prevent a possible fuel leak. During normal operation, the 0-rings located in the
