DeVille Concours V8-4.6L VIN Y (1995)
49.
Remove the fuel rail bracket bolt from the engine lift bracket.
50.
Remove the fuel injector sight shield studs and spacers.
51.
Disconnect the fuel injector wiring harness from the 8 fuel injectors and reposition the fuel injector wiring harness.
52.
Remove the grounding harness bolt from the front of the right (rear) cylinder head.
53.
Remove the fuel rail ground harness.
Notice
Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints,
lubricants or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint
clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid
damage to parts and systems.
54.
Reinstall the grounding harness bolt with the ECM/ignition coil ground harness.
Tighten
Tighten the grounding harness to 25 Nm (18 lb ft).
