DeVille d Elegance V8-4.6L VIN Y (1998)
7.2. Remove the 2 brackets (2) from the sides of the radio control head.
7.3. Remove one 16 mm (0.63 in) plastic locating pin and clip stud from the rear of the control head.
7.4. Remove the driver information display switch and bracket (1).
INSTALLATION PROCEDURE
1. If you are using an exchange radio, perform the following additional steps:
1.1. Install the driver information display switch bracket (1).
1.2. Install one 16 mm (0.63 in) plastic locating pin and clip stud to the rear of the control head.
1.3. Install the 2 brackets (2) to the sides of the radio control head.
NOTE: Refer to Fastener Notice in Cautions and Notices.
1.4. Install the mounting bracket fasteners.
Tighten
Tighten the fasteners to 6 N.m (53 lb in).
2. Connect the harness connectors (1, 2, 3).
3. Connect the antenna coax cable (4).
