DeVille d Elegance V8-4.6L VIN Y (1998)
1. Install the spark plug and cam cover seals as required.
2. Install the cam cover.
NOTICE: Refer to Fastener Notice in Service Precautions.
3. Install the cover screws. Tighten the screws to 10 Nm (89 inch lbs.).
4. Raise the engine cradle into position and install two mounting bolts. Tighten the bolts to 100 Nm (74 ft. lbs.).
5. Install the right and left torque struts. Adjust to provide zero preload.
6. Secure the wiring harness to the cam cover with three screws.
7. Secure the purge canister solenoid with one screw.
8. Connect the PCV valve.
9. Install the spark plug wires and secure the DIS to the cam cover with four screws.
10. Connect the DIS electrical connectors.
11. Install the tower-to-tower brace.
12. Raise the vehicle.
13. Connect the Exhaust Manifold Rear Pipe to the catalytic converter with two bolts. Tighten the bolts to 25 Nm (18 ft. lbs.).
14. Connect the negative battery cable.
